Description
If you're running a custom cooling setup or a chassis that requires you to piece together multiple radiator hoses to make work, this kit will allow you to make it clean and easy for your K-swap.
Rather then using a standard 32mm pipe, this is a billet aluminum barb hose joiner to ensure your hose will stay on under the pressure and heat.
The Power grip clamp will eliminate the need to use unsightly worm clamps all over the radiator hose. It will allow you to make a radiator hose look almost as if it came that way from factory. Ensuring a permanent super tight seal, which will not over/under tighten.
Power Grip Hose:
- Engineered to conform to any shape of hose or housing, even out of round fittings
- Easy to install and only require a heat gun
- Made from a heat-sensitive thermoplastic with a memory to prevent over/under-tightening
Each Kit:
1 x billet aluminum hose joiner
2 x Power grip hose clamp
Note: Do not use a knife to cut the cardboard. Crush the cardboard tube to remove the power grip hose clamp.
