Nissan OEM rear trans seal.
If you are removing your drive shaft of trans off, we recommend you to inspect the rear trans seal to make sure there are no leaks.
If you notice oil around the seal, replace it with a genuine Nissan seal.
*fits both KA and SR trans.
Quick view
Touge Factory
Most 240sx have the center driveshaft carrier bearing shot and will move under load.This will cause vibration and knocking noise. Aluminum 1-piece driveshaft eliminates the need for a bearing...
Quick view
Nissan
Genuine OEM Nissan SR20DET / KA24DE thermostat.
Quick view
Touge Factory
This is for SR20DET's with CD009 Trans swap only. Most 240sx have the center driveshaft carrier bearing shot and will move under load.This will cause vibration and knocking noise. 3" Aluminum...
Quick view
Nissan
Genuine OEM Nissan front transmission gasket.
Quick view
Nissan
Typically if you notice oil leaking near the crank pulley, it could be the front main seal.
Quick view
Nissan
Genuine OEM Nissan ehxaust manifold nut. *Sold individually
Quick view
Radium Engineering
Click Here to download installation instructions (PDF).These are the same machined aluminum injector seats used in Radium fuel rail kits. They are required when converting an OEM side feed...
Quick view
Nissan
Genuine OEM Nissan Crankshaft for SR20DET (RWD).It's common to find warped SR cranks when the engine has been modified. We recommend using a genuine OEM crank if you have deep scores from spun...
Quick view
Nissan
OEM Nissan Valve Cover Gaskets fit all S13/S14 240SX models equipped with a KA24DE powertrain. Replacement of the valve cover gasket is recommended whenever the valve cover is removed to lessen the...
