Description
Application: Universal; comes with 3/4-16UNF & M20X1.5 fitting
New restyled billet aluminum thermostatic oil cooler adapter for your high-performance
motor. This adapter sandwich kit also has a built-in 180°F (82°C) thermostat which
automatically bypasses the oil cooler until the oil has reached its minimum/safe operating
temperature. Prolonged use of an engine in conditions where the oil cannot reach its correct
working temperature will cause sludge formation and crankcase oil dilution, leading to
excessive wear especially in the cylinder bores. The elimination of drag in engines caused by
cold oil is a most important consideration, especially with a racing engine. Additionally, revving
the engine without load will not put much heat into the oil, and devices for preheating the oil
may not be available. Optimum engine power will only be delivered at correct temperatures.
When used in conjunction with an oil cooler results in quicker engine warm-ups and prevents
oil viscosity loss in colder conditions. And now, it comes with a Viton ring for ORB fittings to
ensure a complete seal.
New V2 Kit comes with:
- A straight bolt-on design to be used with -10AN Oil Cooler Kit.
- It comes with 2 different oil housing center fitting, M20X1.5 & 3/4-16UNF.
- 2 X -10AN JIC flared 37º thread ORB outlet port for easy oil cooler installation.
- 2 X 1/8 NPT for oil temp/pressure sensor insert ports, Come with JIC flared 37º thread ORB end
caps.
NOTE: This is a universal application adapter for engine that equipped with 3/4-16UNF or M20X1.5 fittings.
Please verify your filter adapter thread pitch before purchases.
